14
Cordless Chain Saw
EN
2
2/3
1
1/3
Fig.4
When the log is supported on both ends, as
illustrated in Figure 5, cut 1/3 the diameter from the
top (overbuck) (1). Then make the finished cut by
underbucking (2) the lower 2/3 to meet the first cut.
1
2
2/3
1/3
Fig.5
When bucking on a slope always stand on the uphill
side of the log, as illustrated in Figure 6. When
“cutting through”, to maintain complete control
release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw
handles. Don’t let the chain contact the ground. After
completing the cut, wait for the saw chain to stop
before you move the chain saw. Always stop the
motor before moving from tree to tree.
To Next Page
Loading...
Need help?
General
