1312
13A Electric Pressure Washer EN
12
TROUBLESHOOTING
Symptom Possible causes Solution
Machine does not
start when the switch
is in” ON/I”position.
Power cord is not plugged in Plug in power cord
Socket is defective Check or replace plug, socket, fuses
GFCI is triggered Press reset on GFCI plug
Machine pressure is
not consistent.
Pump is faulty Contact service center
Air in line.
Remove the nozzle, turn on the machine for a while
and install the nozzle back.
Water inlet adapter is clogged
or dirty.
Remove the adapter, rinse it with water and put is back.
The pressure of
the pump is not
adequate
water supply is Insufficient open water source completely
Water supply is restricted Check If the water hose kinks or leaks
Diameter of garden hose is
too small
Replace with right garden hose
Leak or kick in hose Replace hose or untie kinks in hose.
No detergent Wrong nozzle is attached Attach the soap nozzle
Lance leaks O-ring needs to be replaced
Replace o-ring .If the problem is not solved ,contact
service center to buy a new lance
To Next Page
Loading...
