TROUBLE SHOOTING
Symptom Possible Cause Remedy
Machine fails to operate Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Mower in long grass
Turn power on
Use another socket
Inspect cable, replace if
damaged
Replace fuse
Increase height of cut and tilt
mower
Machine functions
intermittently
Extension cable damaged
Machines internal wiring
damaged
Inspect cable, replace if
damaged
Contact Service Agent
Machine leaves ragged
Finish or motor labours
Height of cut too low
Cutting blade blunt
Underside of machine badly
clogged
Blade fitted upside down
Increase height of cut (see “
ADJUSTING THE CUTTING
HEIGHT ”)
Replace blade
(see “Blade Maintenance”)
Clean machine
(see “Storage”)
Refit blade correctly
(see “Blade Maintenance”)
Cutting blade not rotating
while machine switched on
Cutting blade obstructed
Blade nut/bolt loose
Clear obstruction
Tighten blade nut/bolt
Excessive vibration/noise Blade nut/bolt loose
Cutting blade damaged
Tighten blade nut/bolt
Replace blade
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
To Next Page
Loading...
