Name: Worx WG761
Brand: Worx
Rating: 5 (1 reviews)

Questions and Answers:

M
Margaret BrandtJul 28, 2025
What to do if Worx Lawn Mower doesn’t run?
- M
  Michael GuzmanJul 28, 2025
  If your Worx Lawn Mower doesn’t run when the operating bail is activated, first ensure the safety lock-out button is completely pushed. Turn the mower off, remove the batteries, and check if the blade can turn freely. If not, return it to an authorized servicer. Also, verify the battery is fully charged. Try raising the cutting height of the wheels to the highest position and starting the mower. Avoid overloading the mower by slowing down the cutting pace or raising the cut height, or both.
J
James FloresAug 2, 2025
Why Worx WG761 Lawn Mower has low run-time?
- C
  Cindy WallAug 2, 2025
  If your Worx Lawn Mower shows low or diminished run-time after many uses, it may need a new battery. Return it to an Authorized Service location.
L
Leah HernandezAug 7, 2025
What to do if Worx WG761 Lawn Mower battery charger LED flashes red?
- D
  Dr. Margaret ThompsonAug 7, 2025
  If the battery charger LED flashes red and the battery can’t be charged on your Worx Lawn Mower, it may be due to the battery overheating after continuous use. Remove the battery from the charger and allow it to cool to 42°C or less.
D
David ChandlerAug 12, 2025
Why Worx WG761 cutting performance is unsatisfactory?
- S
  Stephanie SinghAug 12, 2025
  If your Worx Lawn Mower's cutting performance is unsatisfactory, several factors could be at play. Make sure the battery is fully charged by plugging in the charger until the green light comes on. Turn the mower off, remove the batteries, and check the blade for sharpness and the deck/discharge chute for clogs. The wheel height adjustment might be too low; try raising it. Also, check each wheel for free rotation. Inspect the blade for bends or damage, replacing it if necessary. If the underside of the deck is damaged, return the mower to an authorized service center. You can also try removing the batteries and blade, rotating the blade 180 degrees, and retightening it.