14
Cordless Lawn mower EN
VIBRATION INFORMATION
Typical weighted vibration a
h
= 0.494 m/s²
Uncertainty K = 1.5 m/s²
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
ACTION FIGURE
ASSEMBLY
Assembling the handle bar See Fig. A1
Adjustment of Handle’s height See Fig. A2
Assembling the grass collection
bag
See Fig. B
Assembling the grass collection
bag to the lawn mower
NOTE: Depress the grass collec-
tion bag slightly to ensure that it is
completely installed.
NOTE: Take the mulching insert
out of the lawn mower before fit-
ting the grass collection bag.
See Fig. C1, C2,
C3
Removing/emptying grass
collection bag
WARNING! Always check
the safety flap close the
discharge outlet before using.
Never lift the safety flap when the
lawn mower is being used without
fitted grass collection bag.
See Fig. D
Installing mulching insert See Fig. E
-Removing /fitting the battery pack
NOTE: This machine will only run
when 2 batteries are installed. It
is recommended to use the same
two batteries and charge the two
batteries at the same time.
When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
See Fig. F1, F2
Checking the battery charge
condition
NOTE: Fig. G1 only applies for the
battery pack with battery indicator
light.
See Fig. G1
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must
be fully charged before the first
mow.
Always fully charge the two
batteries at same time. More
details can be found in charger’s
manual.
See Fig. G2
OPERATION
To Next Page
Loading...
