EasyManua.ls Logo

Worx WR130E - Page 14

Worx WR130E
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Getting started
EN
14
Secure the wire to the ground using pegs
Place pegs at approximately 80cm to each other (fig. 6)
Make sure the wire is always in close touch with the ground (fig. 7)
Lay perimeter islands, if needed
Protect flower beds, ponds, tree roots and other areas by surrounding them with the boundary wire
Depart the edge at a right angle to reach the area to be protected
Surround the area with the wire, keeping 26cm distance, until you close the island
Always lay the wire clockwise. Failing to do so will make the mower drive into the island
Return to the edge of the lawn following the same path
80cm
80cm
80cm
6
7
8
Bertelsen method: how to make perfect 90° angles with corners facing the lawn
If there are 90 degree corners that face the inside of your lawn, use the Bertelsen ruler to help Landroid make perfect turns (and remove
the risk that Landroid hits an obstacle on the border of the lawn whilst doing this manoeuvre).
26cm
26cm
26cm
9

Related product manuals