Why Worx WR165E Lawn Mower turns on but the blade doesn't spin?
This is normal: when the Worx Landroid needs to recharge, the blade disc does not rotate while it is searching for the charging station automatically.
What to do if Worx WR165E does not charge?
If your Worx Lawn Mower isn't charging, check that the power cord is properly connected to the charger and the charger is connected to a suitable power supply. Also, ensure both charging strips on the mower touch the center of the contact strips on the charging pile.
What to do if Worx WR165E Lawn Mower operative system crashes?
If the Worx Landroid operative system crashes when charging or on standby, it may be due to a software or display fault. Restart Landroid.
Why does my Worx WR165E Lawn Mower vibrate?
If your Worx Lawn Mower is vibrating, the blade disc may be unbalanced, or the blades may be damaged. Inspect the blades and replace them if necessary. Also, remove any debris or foreign objects from the blades and blade disc.
Why Worx WR165E Lawn Mower LED light on charging pile does not turn on?
If the LED light on the charging pile of your Worx Lawn Mower doesn't turn on, it could be due to a lack of power. Check that the charging station is properly connected to the charger and that the charger is connected to a suitable power supply.
Why does the green light turn on early on my Worx WR165E?
If the green light on the Worx Lawn Mower charging pile turns on before charging is complete, the charging station may be overheating or overcooling. Place the charging station in a shady area or wait until it reaches the normal temperature.
What to do if Worx WR165E says ‘Outside working area!’?
If your Worx Landroid displays ‘Outside working area!’ even when inside the boundary, the boundary wire ends may be clamped incorrectly. Reverse the boundary wire ends and reconnect them to the charging station.
How to fix Worx WR165E charging pile LED light?
If the LED light on the Worx Lawn Mower charging pile doesn't turn on, there may be no power. Check the charging station is properly connected to the charger, and that the charger is connected to a suitable power supply.
Why is the Worx WR165E Lawn Mower charging time so long?
If your Worx Lawn Mower takes much longer to charge than normal, it could be due to: * A poor connection caused by debris on the charging strip. Clean the contact pins on the charging pile and the charging strip on Landroid with a cloth. * The charging protection program being activated due to high temperature. Place the charging station in a shady area or wait until the temperature cools down.
Why is there a red light on my Worx WR165E Lawn Mower charging pile?
A red light on the Worx Lawn Mower charging pile indicates that the boundary wire isn’t connected. Check that the boundary wire has been connected correctly to the charging station and that there are no breaks in the boundary wire.
Read all warnings and instructions carefully. Failure to comply may result in injury.
Never operate with defective guards, keep hands/feet away from blades, avoid bad weather.
Switch off power for maintenance, keep fasteners tight, inspect weekly, use correct charger.
Do not dismantle, short-circuit, or expose battery to heat. Handle leaks safely.
Read manual before use. Keep safe distance. Do not ride on machine.
Lists common error messages and their initial troubleshooting steps.
General| Battery Voltage | 20 V |
|---|---|
| Battery Capacity | 2.0 Ah |
| Power Source | Battery |
| Cutting Height Adjustment | Central |
| Cutting System | Rotary Blade |
To Next Page
