17
EN
NOTES
A. Before turning power on, always check Landroid is inside its working area. If not, the message “Outside working area! Press START to
reset” will be displayed. This message is also displayed when Landroid is partly but not completely inside its working area
B.If for any reason—i.e. a party, children playing...—you want to park your Landroid in the charging station: press home then OK. Landroid
will go to its base and stay there. Please note Landroid will now wait until the next scheduled mowing session. If you want to re-start it
at anytime, press start then OK to start your Landroid
C.If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so please refer to the
installation instructions and check your set up is correct with its help
D.If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging station: when Landroid runs out of charge, take it manually to the charging station
E. If Landroid runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then restart it. If the
problem cannot be solved, please contact our Customer Service for help
7. TROUBLE SHOOTING
If your Landroid does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer Service.
SYMPTOM CAUSE SOLUTION
The LED light on the charging
pile does not turn on.
There is no power. Check the charging station is connected properly to the charger
and the charger is connected to a suitable power supply.
Red light on the charging
pile.
The boundary wire isn’t
connected.
Check that the boundary wire has been connected correctly to the
charging station. Check there are no breaks in the boundary wire.
Landroid turns on, but the
blade disc does not spin.
Landroid is searching for the
charging station.
This is normal: when Landroid needs to recharge, the blade
disc does not rotate while it is searching for the charging station
automatically.
Landroid vibrates. The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
Grass is being cut
unevenly.
Landroid does not work enough
hours per day to cut the grass.
Try adding more hours to the mowing schedule.
Mowing area is too big for the
size of Landroid you have.
Try decreasing the size of the mowing area or increasing working
time.
The blades are dull and not sharp.
Change all the blades and screws in order to balance the bade disc.
The cutting height is set too low
for the length of the grass.
Raise the cutting height and then gradually lower.
Grass or another object has
wrapped around the blade disc.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
There is a build-up of grass in the
blade disc or motor frame box.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Your Landroid is inside
its working area and
the boundary wire is
connected, but the
display says ‘Outside
working area!
Press START to reset’
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends and reconnect to the charging
station.
The charging time is
far more than the rated
charging time.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid using a cloth.
The charging protection
program is activated due to high
temperature.
Place the charging station in a shady area or wait until the
temperature has cooled down.
The mower does not
charge.
There is no power. Check the power cord is connected properly to the charger and
the charger is connected to a suitable power supply.
Make sure both the charging strips on the mower touch the
center of the contact strips on the charging pile.
To Next Page
Loading...
