Worx WX333 Safety And Operating Manual

Rotary hammer WX333
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. ADJUSTING THE AUXILIARY HANDLE (See
A )
For your personal safety we recommend using the
auxiliary handle at all times.
To adjust the handle, rotate the bottom of the handle
anti-clockwise and rotate the handle around the
hammer collar until the handle is in the desired
position. Tighten fully.
2. USING THE DEPTH GAUGE (See A)
The depth gauge can be used to set a constant depth
to the drill.
Rotate the locking screw on the top of the handle
anti-clockwise to loosen, insert the depth stop into
the handle. Adjust it to the desired depth. Rotate the
locking screw clockwise to tighten.
3. FITTING BITS OR CHUCK (See B1)
Clean the bit shank and apply grease before installing
the bit. Hold the rotary grip, pull back the lock sleeve
and insert the bits or chuck into the bit holder. Turn
the bit and push it in until a resistance is felt. The
shaft drops completely into the bit holder. Once you
are satisfied that it has been seated, release the black
lock sleeve. This would lock the bits or chuck into
position.
After installing, always make sure that the tool or
chuck is securely held in the bit holder by trying to
pull it out.
If the bits or chuck is not located well, repeat the
operation again.
4. REMOVE BITS OR KEY CHUCK (See B1)
To remove the tool or chuck, pull back the lock sleeve,
hold and pull the tool or chuck out.
NOTE: The bits or chuck are gripped firmly by
the shank and can not be removed once locked in
position.
5. USING THE CHUCK
For added convenience, your rotary hammer drill now
comes with a 3-jaw chuck. It enables you to work with
non-SDS drill bits/tools.
WARNING! The 3-jaw chuck is designed for
wood and metal DRILLING work only. NEVER
use this chuck with rotary hammer or chisel. THIS
! " "
!
!
!
& ' (
) * +
, - .
# $ %
! " "
! " "

Worx WX333 Specifications

General

Drilling	Yes
Chuck type	SDS Plus
Motor type	Brushed
Screwdriving	-
Product design	Pistol grip drill
Idle speed (max)	750 RPM
Chuck capacity (max)	- mm
Impact rate (high speed)	3700 bpm
Drilling diameter in wood (max)	40 mm
Drilling diameter in steel (max)	13 mm
Drilling diameter in concrete (max)	32 mm
Product color	Black, Orange, White
Cable length	2.8 m
Output power	1250 W
Power source	AC
AC input voltage	220 V
Impact energy (max)	5 J

Weight and Dimensions

Depth	180 mm
Width	490 mm
Height	350 mm
Weight	6100 g