EasyManuals Logo

Worx WX425 User Manual

Worx WX425
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Circular saw EN
11
10
future reference.
These lasers do not normally present an
optical hazard although staring at the beam
may cause flash blindness.
Do not stare directly at the laser beam. A
hazard may exist if you deliberately stare into
the beam, please observe all safety rules as
follows:
1. The laser shall be used and maintained
in accordance with the manufacturers
instructions.
2. Never aim the beam at any person or an
object other than the work piece.
3. The laser beam shall not be deliberately
aimed at another person and shall be
prevented from being directed towards
the eye of a person for longer than 0.25
seconds area.
4. Always ensure the laser beam is aimed
at a sturdy work piece without reflective
surfaces, e.g. wood or rough-coated
surfaces are acceptable. Bright shiny
reflective sheet steel or similar is not
suitable for laser applications as the
reflective surface may direct the laser beam
back at the operator.
5. Do not change the laser device with a
different type. The manufacturer or an
authorized agent must carry out repairs.
6. CAUTION: Use of controls or adjustments
other than those specified herein may
result in hazardous radiation exposure.
ADDITIONAL SAFETY WARNING FOR
CLASS 2 LASER
The laser device fitted to this tool is CLASS
2 with a maximum radiation of 1mW and
650nm wavelength.
CLASS 2 LASER RADIATION, DO NOT
STARE INTO BEAM
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or retailer for
recycling advice.
Laser radiation
Do not stare into beam
SYMBOLS

Other manuals for Worx WX425

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Worx WX425 and is the answer not in the manual?

Worx WX425 Specifications

General IconGeneral
Blade diameter160 mm
Idle speed (max)5000 RPM
Sound power level93 dB
Bevel capacity (max)45 °
Cutting depth (45º)38 mm
Cutting depth (90º)55 mm
Sound pressure level82 dB
Sound level uncertainty3 dB
Vibration level (wood cutting)4.36 m/s²
Vibration level uncertainty (wood cutting)1.5 m/s²
Input power1200 W
Power sourceAC
AC input voltage230 - 240 V
AC input frequency50 / 60 Hz
Motor typeBrushed
Product colorGrey, Orange, Stainless steel, White
Built-in lightNo
Protection classII
Dust extraction portYes
Suitable for materialsWood
Weight and Dimensions IconWeight and Dimensions
Width340 mm
Weight3500 g

Related product manuals