Need help?Do you have a question about the Worx WX424 HandyCut and is the answer not in the manual?
Ensure proper plug use, avoid earthed contact, protect from water, and use outdoor cords.
Stay alert, use PPE, prevent unintentional starting, maintain balance and proper dress.
Don't force the tool, ensure switch works, disconnect power for adjustments, store properly, maintain tools.
Always wear a dust mask, hearing, and eye protection. Wear gloves when handling blades.
Maintain firm grip, position body to side, release trigger when binding, center blade when restarting.
Do not stare at the beam, aim only at work piece, avoid prolonged eye exposure.
Tool may cause HAVS if not adequately managed; consider idle times.
Steps to safely unplug, loosen, remove, install, and tighten the blade.
Setting the correct blade depth, suggested depths for materials.
How to activate and stop the saw using the trigger and safety release switch.
Setting up, positioning, and starting a cut safely and effectively.
Aligning cut lines, performing cross and rip cuts.
How to make plunge cuts into solid surfaces or work pieces.
To Next Page
General
