hazards.
4. POWER TOOL USE AND CARE
1) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool will
do the job better and safer at the rate for
which it was designed.
2) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
3) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
4) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users.
5) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
6) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
7) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. SERVICE
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
2) If the replacement of the supply cord
is necessary, this has to be done by
the manufacturer or his agent in order
to avoid a safety hazard.
ADDITIONAL SAFETY
RULES FOR YOUR MINI
MULTI-FUNCTION SAW
1. Always wear a dust mask, hearing
protection and eye protection.
2. Only use saw blades recommended for use
with this model.
3. Always wear gloves when handling saw
blades and rough material. Saw blades
shall be carried in a holder whenever
practicable.
4. Fully unwind cable drum extension to
avoid potential overheating.
5. When an extension cable is required you
must ensure it has the correct ampere
rating for your power tool and is in a safe
electrical condition.
6. Ensure your mains supply voltage is the
same as indicated on the rating plate.
7. Your mini multi-function saw is a hand held
tool, do not clamp your mini multi-function
saw to a workbench.
8. Before cutting, ensure the work piece is
free of nails, screws, etc.
9. Do not cut small work pieces with a mini
multi-function saw. If possible, use a
jigsaw.
10. Only make cuts with the blade direction
downwards, never upwards or at the side.
11. Do not use a blade unless the rated blade
speed exceeds the saw no load speed.
12. Never remove the guard system. Never
use the saw if the guard system does not
function correctly. Never lock the moving
guard open. The guard must move freely.
13. Always check walls, floors and ceilings to
avoid hidden power cable and pipes.
14. After long working periods external metal
parts and accessories could be hot.
15. Do not cut material containing asbestos.
16. Do not use mini multi-function saw to cut
To Next Page
Loading...
Need help?
General
