Circular saw with laser EN
9
SYMBOLS OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for lengthways and
crossways cutting of wood with straight cutting lines
as well as bevel angles to 51° while resting firmly on
the work piece.
1. DEPTH OF CUT ADJUSTMENT (See Fig. A)
Lift the depth of cut lock lever and raise the saw body
away from the base plate. Set the depth of cut with
the scale and push the lever down to lock. Always
add 3mm to your depth of cut so that the blade can
cut through the material.
2. BASE PLATE ANGLE ADJUSTMENT (See Fig.
B1 & B2)
Turn the base plate bevel lock (6) in anti-clockwise
direction to loosen the angle scale. Tilt the base plate
away from the machine until the required cutting
angle is adjusted on the angle scale (5). Tighten the
bevel lock (6) by turning it in clockwise direction.
USING THE CIRCULAR SAW
1. SAFETY ON/OFF SWITCH (See Fig. C)
Your switch is locked off to prevent accidental
starting. Depress the lock off button then the on/off
switch and release the lock off button. Your switch is
now on. To switch off, just release the on/off switch.
You can depress the lock-off button from either side
of the button.
2. PARALLEL GUIDE ADJUSTMENT
(See Fig. D)
It is used for making cuts parallel to a workpiece edge
at a chosen distance. Slide the parallel guide arm
through the fixture to achieve the required cutting
distance then tighten the lock knob to clamp. It can be
used from both sides of the base plate. For straight
cuts, use the 0° guide mark to align with your parallel
guide scale. For a 45° bevel cut, use the 45° guide
mark to align with your parallel guide scale. Securely
clamp the parallel guide.
NOTE: It is best to carry out a trial cut.
3. CHANGING THE SAW BLADE
(See Fig. E, F, G)
• Before any work on the machine itself, pull
the mains plug.
• Wear protective gloves when mounting the
saw blade. Danger of injury when touching the
saw blade.
• Only use saw blades that correspond
with the characteristic data given in the
operating instructions.
• Do not under any circumstances use
grinding discs as the cutting tool.
For changing the cutting tool, it is best to place the
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Laser radiation
Do not stare into beam
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or
retailer for recycling advice.
To Next Page
Loading...
