12
5-in-1 Multi Sander
EN
TECHNICAL DATA
Type Designation WX820 WX820.1 WX820.9
(82-designation of machinery, representative of
Multi Sander)
WX820 WX820.1 WX820.9
Charger Volt-
age
100-240V ~ 50/60Hz
Voltage
20 V Max**
No-load
speed
4000-10000 /min
Orbital diam-
eter
Random orbit-2.5mm, Finish-1.8mm,
Detail-1.8mm
Speed
settings
1-6
Machine
weight
2.0kg 1.5kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.
NOISE INFORMATION
A weighted sound pressure L
pA
: 77.6dB(A)
A weighted sound power L
wA
: 88.6dB(A)
K
pA
&K
wA
3 dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission
value:
a
h
=3.731m/s
2
Uncertainty K = 1.5m/s
The declared vibration total value and the declared noise emission
value have been measured in accordance with a standard test
method and may be used for comparing one tool with another.
The declared vibration total value and the declared noise emission
value may also be used in a preliminary assessment of exposure.
WARNING The vibration and noise emissions during
actual use of the power tool can differ from the declared
value depending on the ways in which the tool is used especially
what kind of workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp
and in good condition.
The tightness of the grip on the handles and if any anti vibration and
noise accessories are used.
And the tool is being used as intended by its design and these
instructions.
This tool may cause hand-arm vibration syndrome if its use is
not adequately managed.
WARNING To be accurate, an estimation of exposure level
in the actual conditions of use should also take account of
all parts of the operating cycle such as the times when the tool is
switched off and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep
well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration and
noise accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
ACCESSORIES
WX820 WX820.1 WX820.9
Battery pack
(WA3551.1)
11 /
Battery pack
(WA3553)
/1 /
Charger
(WA3880)
11 /
Finishing plate 1 1 1
Random Orbit
plate
11 1
Detail plate 1 1 1
Finger plate 1 1 1
Contour plate 1 1 1
Dust bag 1 1 1
Paper punch 1 1 1
To Next Page
Loading...
