Roborover has several different function modes and games
Explore Mode
In Explore Mode, Roborover can explore around his environment without your
commands; he can detect and avoid obstacles as he goes, and make comments
To enter Explore Mode, press the Explore button on the remote controller After approximately
3 minutes, he will exit Explore Mode and enter Standby Mode (refer to page 11 for
details) To exit Explore Mode before this, press the Stop button on the remote controller
Lookout Mode
In Lookout Mode, Roborover will scan his immediate environment in front of and behind
him He can then sound an alarm if he detects movement or a change to the environment
NOTE: You cannot give Roborover drive commands while he is in Lookout Mode
To activate Lookout Mode, do the following:
Press the 1 Lookout button on the remote controller Roborover will make a comment
Press the 2 Lookout button again
When he rst enters 3 Lookout Mode he will perform a long range scan of his
immediate environment in front of, and behind him This is approximately 4-6 feet
(12-18m) depending on the environment If there are objects nearby he will
perform a short range scan, this is approximately 12 inches (30cm)
When Roborover detects any movements or new objects, he will sound an alarm 4
If Roborover detects something, he will remain in 5 Lookout Mode If he does not
detect anything for about 10 minutes he will exit Lookout Mode and wait for
a command If you do not enter a command within 2 minutes, he will enter
Standby Mode (refer to page 11 for details) To exit Lookout Mode before the
10 minutes is over, press the Stop button on the remote controller When he
exits Lookout Mode, he will tell you if he saw anything
To Next Page
Loading...
