Installing or changing batteries in the remote controller
Open the battery compartment on the remote controller using a Phillips 1
screwdriver (not included) to remove the screw on the battery compartment cover
Insert the batteries according to the diagram Ensure that the positive and 2
negative polarities match the illustrations inside the battery compartment
Replace the battery compartment cover and replace the screw using the 3
screwdriver Do not over-tighten
Important battery information
Use only fresh batteries of the required size and recommended type•
Do not mix old and new batteries, different types of batteries [standard (Carbon- zinc), Alkaline or rechargeable] or •
rechargeable batteries of different capacities
Remove rechargeable batteries from the toy before recharging them•
Rechargeable batteries are only to be charged under adult supervision•
Respect the correct polarity, (+) and (-)•
Do not try to recharge non-rechargeable batteries•
Do not dispose batteries in a re•
Replace all batteries of the same type/brand at the same time•
The supply terminals are not to be short-circuited•
Remove exhausted batteries from the toy•
Batteries should be replaced by adults•
Remove batteries if the toy is not going to be played with for some time•
1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
Battery
compartment
cover
To Next Page
Loading...
