WowWee Tri-bot - Modes Program Mode

Modes
Tri-bothasseveraldifferentfunctionmodesandgameswhicharedescribedinthis
section.
Program Mode
InProgram Modeyoucanprogramandstoreasequenceofupto60drivecommand
programstepsthatTri-botcanplaybackonrequest.Hecannotdetectoravoid
obstacleswhileheisinProgram Mode.
ToenterProgram Mode,dothefollowing:
1.PresstheProgrambutton.Tri-botwillmakeacommentwhenheisready
toreceivedrivingcommands.
2.UsethedirectionpadontheremotecontrollertodirectTri-bot’smovements.He
willstorethelengthofthemovementasasingleprogramstep.
3.Toaddmoreprogramsteps,repeatstep2.
4.Ifyouwanttoaddapausetothesequence,presstheSTOPbutton.Thelength
oftimeyouholdthebuttonwillbeequaltothelengthofthepause.
5.Whenyouhavenished,pressthePlaybackbutton.Tri-botwillexit
Program Modeandplaytheprogramback.
NOTE: Ifyoudonotenteranycommandsforapproximately30seconds,
Tri-botwillstoretheprogramandexitProgram Mode.
6.Tocleartheprogram,enterProgram Mode bypressingtheProgrambutton
andpressthePlaybackbutton,withoutenteringanydriveinstructions.
Toplaybacktheprogramatanytime,pressthePlaybackbutton.Tri-botwillnot
rememberanystoredprogramsonceyouturnhimoff.
NOTE:Tri-botcanonlystoreoneprogramatatime.Ifyoustoreanewprogram,you
willoverwriteanddeletethepreviouslystoredprogram.
Modes - Program Mode
9