WowWee Tri-bot - Battery Details Tri-Bot

Battery details - Tri-bot
Battery details
Battery requirements
Tri-botrequires8x“AA”sizealkalinebatteries(notincluded).
Theremotecontrollerrequires3x“AAA”sizealkalinebatteries(notincluded).
Installing or changing batteries in Tri-bot:
TochangethebatteriesinTri-bot,rstcarefullylayhimonhisback.Donotbalance
himorplacehimnearatableedge.Installthebatteriesasfollows:
1. UsingaPhillipsscrewdriver(notincluded)removethescrewsonthe 
 batterycompartmentcoverlocatedontheundersideofTri-bot’swheel
 base.
2. Insertthebatteriesaccordingtothediagram.Ensurethatthepositiveand
 negativepolaritiesmatchtheillustrationsinsidethebatterycompartment.
3. Replacethebatterycompartmentcoverandreplacethescrewsusingthe
 screwdriver.Donotover-tighten.
NOTE:YouwillknowwhenTri-bot’sbatteriesarenearlydepletedbecausehewill
makeacomment.
4