BASE UNIT
600 - 1000 Hob
2/3 Drawer
Standard Drawer
Assembly
For Internal Use: FI.WR.INS.058_WKIN00112_BASE_600-1000_2-3Drw_Hob_Rev1.indd Page 2
Step 2.
Clip on metal back
panel to drawer base
& drawer sides.
Step 3.
Screw back panel in position
using 2 x 16mm screws
to drawer base in holes
provided.
Step 1.
Secure drawer base to drawer side using 4 x 16mm
drawer runner screws (J) in holes provided.
Seat the edge of drawer base tight
into corner of casing, as shown.
The decorative face of drawer base
to be positioned as shown.
View from
back
Front of drawer
View on side of drawer side
Decorative
face
Drawer
base
1
3
2b
2a
Metal back
panel
Metal back
panel
Drawer base
white decorative
face up
J
J
J
J
J
J
J
J
J
J
Step 4.
Frontal Attachment
Secure drawer side xing clips
using 2 x 21mm screws (Q) in
pilot holes provided as shown.
Step 5.
Draw Adjustment
Screw point 1 as shown
to adjust drawer
frontal right & left.
Drawer
base
Fixing
clip
& (Q)
Fixing
clip
& (Q)
Standard
drawer
Step 6.
Fit Drawer Cover Caps
over drawer side adjustment.
Screw point 2a as
shown to adjust
drawer frontal
up & down.
Tighten 2b
once in position.
Releasing Screw
point 3 whilst applying
downward pressure as
shown to release.
Drawer
Cover Cap
Fixing
clip
Drawer Frontal Adjustment
Drawer
frontal
Drawer
side
Drawer side
xing clip
Q
Q
J
Drawer
frontal
Repeat step 1 so both drawer
sides are attached to drawer base.
99mm
67mm
99mm
67mm
To Next Page
Loading...