Bulletin # 055
6 Pages
May 10, 2006
liability for consequential damage will be on the selling
Dealer.
This work is to be done in conjunction with Bulletin #056
The Fix: Using the attached instructions:
1) Remove the hydraulic oil cooler from all affected mowers
2) ONLY IF MOWER RETAILED - Remove the engine shroud
and clean the engine cooling area and fins with compressed
air
For units that have been retailed, contact the end-user to have
these services performed. Units that have been retailed but
not registered must be registered immediately.
*** All affected mowers need to have this update performed.
No affected mower should be retailed without this service being
performed
*** The engine manufacturer recommends cleaning the
dust, dirt and debris from cylinder and cylinder head
cooling fins every 100 hours or more often under dusty
conditions. Grass clogged cylinder heads and cooling fins
can contribute to engine overheating and we strongly
recommend this service item be done frequently. Please
take this opportunity to perform this necessary
maintenance service. The plastic engine shroud must be
removed to perform this service.
Claim
Procedure: 0.6 hour of labor allowed. An additional 0.4 is allowed for
cleaning the engine cooling fins if the unit has been retailed.
Complete the attached “Quick-Claim-Form” and submit within
15 days of the date of repair. Work must be performed at the
same time as Bulletin #056 and should be claimed on the same
claim form.
11
To Next Page
Loading...
