WRIGHT WSR52 - Cutting Deck Baffle System

Cutting Deck Baffle System
Installation Instructions
1. Remove deck covers.
2. Raise and secure unit so cutter deck is accessible.
3. Mount baffle as shown in figures using hardware included.
Note:
*Some older units may not have holes pre-punched. See
instructions
for mounting and drilling holes.
4. Spin blades by hand to make sure blades will not hit baffle.
Note:
*If spindle is the type with 2 spacers between the blade and the spindle
then one spacer needs to be removed.
*Standers and Velkes must have all blade spacers installed. (5ea.
Spindle)
NOTES:_____________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
44