wsm V3307-DI-T-E2B - Governor Connecting Rod Jig

G-40
V3307-DI-T-E2B, WSM
G GENERAL
Jig for Governor Connecting Rod
Application : Use for connecting the governor connecting rod to the rack pin of the fuel injection pump assembly.
A 0.50 mm (0.020 in.) O 5.0 mm (0.20 in.)
B 12.7 to 13.0 mm (0.500 to 0.511 in.) P 4.0 mm (0.16 in.)
C 8.70 to 9.00 mm (0.343 to 0.354 in.) Q 2.955 to 2.965 mm dia. (0.1164 to 0.1167 in. dia.)
D 39.0 mm (1.54 in.) R 3.020 to 3.030 mm dia. (0.1189 to 0.1192 in. dia.)
E 10.0 mm (0.394 in.) S Ra = 1.6 a
F 7.0 mm (0.28 in.) AA Governor housing side
G 6.0 mm (0.24 in.) BB Press in side
H 80.0 mm (3.15 in.) a 0.60 mm radius (0.024 in. radius)
I 27.95 to 28.05 mm (1.101 to 1.104 in.) b 1.0 mm radius (0.039 in. radius)
J 5.0 mm (0.20 in.) C0.2 Chamfer 0.20 mm (0.0079 in.)
K
3.000 to 3.010 mm dia., 6.0 mm depth
(0.1182 to 0.1185 in. dia., 0.24 in. depth)
C0.4 Chamfer 0.40 mm (0.016 in.)
L 9.0 mm (0.35 in.) C0.5 Chamfer 0.50 mm (0.020 in.)
M 5.0 mm (0.20 in.) C1 Chamfer 1.0 mm (0.039 in.)
N 14.45 to 14.55 mm (0.5689 to 0.5728 in.) C2 Chamfer 2.0 mm (0.079 in.)
(1) Material : S43C-D (2) Permanent Magnet :
8.0 mm dia. (0.31 in. dia.)
Thickness : 3.0 mm (0.12 in.)
(3) Pin Material : SUM22
KiSC issued 01, 2009 A