Need help?Do you have a question about the wtw pH 330i and is the answer not in the manual?
General| Brand | wtw |
|---|---|
| Model | pH 330i |
| Category | Measuring Instruments |
| Language | English |
Provides warnings to avoid injury or damage, detailing specific hazard indicators.
Details the instrument's display layout and the various connection ports for electrodes and sensors.
Explains connecting and using the plug-in power supply for the pH 340i model.
Instructions for powering on the device, including the initial display test and mode activation.
Presents the different measuring modes available and their functions.
Describes specific functions like AutoRead, pH resolution selection, and temperature input.
Describes the fully automatic single, two-point, or three-point calibration using WTW buffer solutions.
Details the automatic calibration method matched to buffer solutions according to DIN 19266.
Explains the conventional two-point or single-point calibration using any buffer solution.
Explains how the instrument automatically evaluates calibration results for asymmetry and slope.
Covers manual and automatic data saving, including setting save intervals and ID numbers.
Explains how to output stored data to the display or serial interface.
Details manual and automatic data transmission to the serial interface for the pH 340i.
Step-by-step guide to configure settings like Baud rate, display options, calibration interval, and date/time.
Instructions for resetting measurement parameters and configuration settings back to factory defaults.
Details dimensions, weight, protection type, safety class, ambient conditions, measuring ranges, and precision.
Provides details on pH correction, analog output, and serial interface specifications.
Covers battery operation, plug-in power supply details, and relevant safety/EMC guidelines.
To Next Page
