SECTION 2 - SYSTEM INSTALLATION
1. General
This section contains system specifications, interface information, and examples of typical system
configurations for the C-5000 Communication Management Controller installed with FLEXCOMM II,
FLEXCOMM I, or a configuration consisting of both FLEXCOMM II and FLEXCOMM I transceivers. System
power requirements are included in Table 2-1. Figures 2-1 through 2- 6 shows generalized system
interface diagrams.
2. Sample Systems
The following are examples of ways to configure your aircraft installation:
Figure 2-1. Single RT-5000 with Active Antenna
Figure 2-2. Single RT-5000 with Passive Antenna
Figure 2-3. Dual RT-5000 with Dual Mic/Headset
To Next Page
Loading...