10
2. Press JOIN to connect the Command Center to the call.
3. You will now be able to communicate with everyone that is active
on this call.
4. You may disconnect from this conversation at any time by hanging
up the Command Center. The calls you joined will stay active until
they have disconnected themselves, or you press the END ALL
CALLS button.
7. Calling multiple stations (paging)
a. Calling multiple stations is accomplished by pressing the PAGE ON/OFF button.
i. The Command Center will ring any phone that is connected to it.
1. This is a one way call only and is for the Command Center to make
announcements.
2. Command center will connect S3 Communicator phones
automatically. Other phones on the line may have to be manually
picked up.
a. S3 Communicator phones set up for line sharing will not
answer a page due to the added menu option required to
reach the phone.
3. The page function will remain “on” until you press END ALL CALLS
to disconnect from all lines that were affected by the page.
a. While page is “on”, placing the handset on the receiver or
pressing SPEAKER ON/OFF will not disconnect the phone
as it typically would in a call. Switch to speakerphone by
placing the handset on the receiver, and switch back to
handset mode by lifting the handset.
8. Ending call with multiple stations
a. To end a call on multiple stations, the easiest and fastest way is to press the END
ALL CALLS button. This of course depends on whether you want disconnect from
one or all of those calls, because pressing that button will end ALL calls.
b. If you just wish to disconnect from one call at a time, then you may do so by
hanging up the phone on a call, which will bring the next call up in the queue to
be answered. This call can be ended by hanging up also and so on down the line
until they have all been ended.
i. You cannot hang up one by one if page was initiated. In this case, you must
END ALL CALLS.
To Next Page
Loading...
