16
ADVANCED OPERATIONS
1. Programming S3C from Command Center
a. You can program any S3C that is connected to the Command Center or accessible
through an external line. Full programming instructions for the S3C are located in
the instruction booklet that came with the phone, on our website Wurtec.com, or
by contacting technical support.
2. Ethernet connectivity
a. RESERVED FOR FUTURE RELEASE
3. USB firmware upgrade support
In addition to allowing the user to modify and store configuration parameters, the
Command Center firmware is field-upgradeable to allow users to have access to new
functionality and features as they become available.
To upgrade the Command Center firmware a Windows 7 or greater laptop or PC with a
USB 2.0 and internet connection is required. In addition, the laptop or PC must have the
Microchip FLIP software application installed. The FLIP software can be installed by
selecting the “FLIP x.x.x.x for Windows (Java Runtime Environment included)” link at :
https://www.microchip.com/developmenttools/ProductDetails/FLIP
Where x.x.x.x is the latest version of the FLIP application.
The Command Center firmware can be obtained by request from:
PhoneSupport@wurtec.com
on request.
To perform a firmware update on the Command Center:
1. Open the Command Center enclosure and locate the F/W Update and Reset
pushbuttons on the S3Pbx PCB and shown in Figure 2 (next page).
To Next Page
Loading...
