Wurtec S3 - Page 15

15
In this scenario Command Center 1 can call Command Center 2 or vice versa via the following steps:
1. Select the extension that the other Command Center is connected to, in this case EXT 001.
2. The other Command Center will answer with its automated response asking for the
number of the phone that you would like to talk to.
3. To ring the other Command Center, directly dial 0.
With S3 Communicators configured to share a line as the elevator phones connected to Command
Center 1, a call can be placed from Command Center 1 to any of the phones via the following steps:
1. Select the extension that the phones are connected to, in this case EXT 003.
2. The S3 Communicators will respond with their automated response asking which phone
(1 – 8 or 0 for all) you want to talk to.
Likewise, to place a call from Command Center 2 to any of the S3 Communicators:
1. Select the extension that the other Command Center is connected to, in this case EXT 001.
2. The other Command Center will answer with its automated response asking for the
number of the phone that you would like to talk to.
3. Dial the extension that the phones are connected to, in this case 3.
4. The S3 Communicators will respond with their automated response asking which phone
(1 – 8 or 0 for all) you want to talk to.
Calling from Command Center 1 to an outside line works the same way as outlined above with a single
Command Center:
1. Dial 99 from the Command Center to get the dial tone from the outside line, then the
number that you want to call.
To place a call to the outside line from Command Center 2 in this scenario:
1. Dial 99 to get a dial tone from Command Center 1.
2. Dial 99 again to get a dial tone from the outside line, then the number that you want to
call.