Need help?Do you have a question about the Wurtec S3 Communicator and is the answer not in the manual?
General| Brand | Wurtec |
|---|---|
| Model | S3 Communicator |
| Category | Emergency Phone |
| Language | English |
Configure the S3C to automatically dial emergency phone numbers using the onboard keypad.
Record a message to identify the location of the emergency call, played to the operator.
Configure a ring-down line where the phone automatically dials a predetermined number when picked up.
Set the duration for how long the first emergency number is dialed, between 30-99 seconds.
Program the Site ID message for the operator, crucial for call tracing.
Record up to three in-car announcements to notify users which emergency number is being dialed.
Control whether in-car announcements and Site ID messages are played.
Enable immediate conversation without an automated message, disabling Site ID.
Allow users to cancel an outgoing call by pressing the call button again.
Enable voice prompts for external power, battery, or telephone line failures.
Configure a prompt before disconnection, allowing users to extend the call.
Set the duration for two-way conversations, with a warning before disconnection.
Enable password protection for remote programming access.
Program an ID for SoundNet capable call centers, requires specific user preferences.
Set the number of rings before the emergency telephone answers a call (0-9).
Assign a unique identification number (1-9) for sharing a single line with multiple S3Cs.
Program external outputs to activate on events like button press or failures.
To Next Page
