Wurtec S3 Communicator - Programming (Locally or Remotely)

16 Buy Online! Wurtec.com Buy Online! Wurtec.com 17
Programming (Locally or Remotely) | Advanced Options
Touch Tone ID
This feature is for programming with SoundNet capable call centers. If this feature is used
make sure Announcements are turned OFF and Immediate Two-Way Conversation is turned
ON. See pages 12 and 13 for those options.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
4
for Touch Tone ID.
STEP 4 Press
1
to program touch tone ID. Press
2
to review what the already
programmed ID is (by default there is no ID). Press
3
to erase the Touch Tone ID
altogether.
STEP 5 Press
#
VOL DN
to return to the previous menu and continue on programming. If you are
nished programming you can press
VOL UP
then
0
to exit program mode.
Ring Count
Use this feature to program the number of rings to occur before the emergency telephone
answers a call. Enter between zero (0) and nine (9). If you enter zero (0) the telephone will
never answer an incoming call. Factory set default is 1.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
5
for Ring Count.
STEP 4 At this point you can press
1
to program desired ring count. Press
2
to review
what the already programmed ring count is (by default the ring count is 1). Press
#
VOL DN
to return to the previous menu to continue on programming. If you are nished
programming you can press
VOL UP
then
0
to exit programming.
Programming (Locally or Remotely) | Advanced Options
Unit Number (Line Sharing)
Use this feature when sharing more than one S3C on a single line. Each phone will need a
unique identication number. Enter a number between 1 and 9. NOTE: If line sharing you
must use “1” as the rst unit number.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
6
for Unit Number.
STEP 4 At this point you can press
1
to program desired Unit Number. You can press
2
to review what unit number is already programmed into the phone (by default
there is no unit number programmed into the phone). You can press
3
to delete
the unit number programmed into the phone.
STEP 5 Once you have chosen an option in step 4 you can at this point press
#
VOL DN
to return
to the previous menu to continue with programming. If you are nished, you can
press
VOL UP
then
0
to exit program mode.
External Output
External output(s) can be programmed to activate on button press, battery failure, external
power failure, and telephone line failure. By default, the external output relay is set to
activate on telephone line power to comply with 2009 code. This output can be used to
trigger a remote alarm board per the 2009 code. WARNING: If using the 2009 code this
feature should NOT be changed from default setting of activating on telephone line
failure.
STEP 1 Press
PROG
MENU
button on the keypad.
STEP 2 Press
3
for advanced options.
STEP 3 Press
7
for external outputs.
STEP 4 Press
1
for rst output.
STEP 5 Press
1
to program. Press
2
to review. Press
3
to disable. Press
#
VOL DN
to
return to external outputs or
VOL UP
then
0
to disconnect. (continued on next page)