18 Buy Online! Wurtec.com Buy Online! Wurtec.com 19
Programming (Locally or Remotely) | Advanced Options
STEP 6
Press
1
to activate on button press, press
2
to activate on battery failure, press
3
to activate on external power failure, or press
4
to activate on telephone
line failure (default). Press
#
VOL DN
to return to rst external output or Press
VOL UP
then
0
to disconnect.
STEP 7
When programming is complete, Press
#
VOL DN
to return to previous menus or Press
VOL UP
then
0
to exit phone programming.
Program Status
The Program Status feature will recite the menu settings that are currently programmed in the
phone. The phone will recite in order the settings for:
- serial number
- S3 Communicator model number
- version number
- programmed phone numbers
- announcements on/o
- immediate two-way conversation on/o
- call cancellation on/o
- maintenance announcements
- timing out
- talk time
- access code
- touch tone ID
- ring count
- ring time
- unit number
- rst external output
STEP 1
Press
PROG
MENU
button on the keypad.
STEP 2
Press
4
and the phone will begin to recite the information stated above.
STEP 3
At this point the phone will automatically revert back to the main program menu.
You can choose any option to continue with programming. If you are nished, you
can press
VOL UP
then
0
to exit program mode.
Calling Into Remote Phone
It is possible to program the S3Communicator from a remote location by calling into the
telephone. Using a dedicated touch tone telephone, dial the phone number of the S3
Communicator.
STEP 1
Once the phone answers you will hear the following: “This is an emergency
telephone. Press
1
to talk,
2
to program, or
VOL UP
then
0
to disconnect.
STEP 2
Press
1
, You will then be in a two way conversation with whomever is currently
in the elevator. If you choose to press
2
it will take you into programming mode
and may prompt for password if one is programmed Or you can choose to press
VOL UP
then
0
which will hang the phone up.
Note: If the phone you are calling is line sharing with another S3 Communicator it
may ask you to enter a unit number. At this point you would need to enter the unit
number of the phone you are trying to reach. Also, if an access code has been
programmed into the phone, it will ask you to enter it in order to continue on to the
phone options stated above in steps 1 and 2.
If you do not know the Access Code you must go to the job site and gain access to
the circuit board keypad and reset to factory defaults or change the access code. If
you are unable to get to the job site, you can call Wurtec Inc. All phone numbers
are listed on troubleshooting page 21.
Reset to Factory Defaults
STEP 1
Press the
VOL UP
and
#
VOL DN
keys at the exact same time.
STEP 2
The phone will then give the option to press
1
to reset back to default. Press
2
to cancel resetting back to default. You also have the option to press
VOL UP
then
0
to exit program mode.
Testing the Phone Line
To make sure you have a good telephone line, you can make an outside call from the S3
Communicator using the onboard keypad. This is a good time to verify emergency numbers.
(continued on next page)
To Next Page
Loading...
