2
4
5
You should take the cleaner out verti-
cally to drain inside water out quickly.
07
1
3
The cleaner begins to clean walls, floor
and waterline as default or your set.
The device will automatically move to
stop by the edge of wall when finishing
cleaning or battery low.
You can insert the included hook into
a pool rod and lift the cleaner out of
the pool.
About 20 seconds of auto calibration
on the floor, the indicator light will turn
flashing blue. The cleaner is ready to
clean.
Note:
If you have preset a cleaning cycle other than the default one, you should leave the
cleaner in the pool to complete the whole cycle.
To Next Page
Loading...
