Step 6 -Cleaning the filter
Email：support@wybotpool.com Facebook: @WybotPool Website: www.wybotpool.com
Step 4 -Submerging the device Step 5 -Removal from the pool
Submerge the device into the pool
gently.
9 10
Wait for the device auto-calibration
for 20 seconds.
LED turns flashing blue and start
to clean.
14 15
Store the cleaner in a ventilated
place and keep it out of direct sun-
light or inclement weather.
Charge the device at least every
3 months to maintain battery per-
formance during the offseason.
11 12 13
Auto park by the wall when
completing cleaning.
Insert the included hook
into a standard pool pole.
Hook it out of the pool.
You should clean the filter after use.
Insufficient cleaning may influence
pool cleaning effect.
Quick Start Guide WYBOT S2(WY210C)
a
b
c d
Cotton foam is an auxiliary filter to help
trap the fine dirty particles.
Recommend
to use it for floor cleaning.
Please do not install it when the pool
water is heavy dusty, it may influence
the operation of the cleaner.
Document No. G2024210C01
MODE
MODE
To Previous Page
Loading...
