1919
1919
19
1818
1818
18
CC
CC
C
ONTROLLINGONTROLLING
ONTROLLINGONTROLLING
ONTROLLING
ANAN
ANAN
AN
IR MIR M
IR MIR M
IR M
INIINI
INIINI
INI
C C
C C
C
ONTROLLERONTROLLER
ONTROLLERONTROLLER
ONTROLLER
(IR543) (IR543)
(IR543) (IR543)
(IR543)
If you already own an IR Mini Controller,
you will need to change the X10 Home
Automation code in the remote to use it.
The code for standard X10 RF Home
Automation is 999. The code to control
the IR Mini Controller is 998. To change
the code:
2.2.
2.2.
2. Press and release
the X10 button.
3.3.
3.3.
3. Enter 998 to control
an IR Mini
Controller, or 999
for standard X10
control. The LED
turns off after the last
digit entered.
Note: In most cases, you will not need
to use the IR Mini Controller to receive
commands from the 5 in 1 Remote - the
Transceiver Module does this for you and
has the added advantage of working
through walls. You can if you wish control
the IR Mini Controller and the
Transceiver Module at the same time. To
do this stores code 999 under the X10
key and store 998 under any other key
(except TV). See page 22 for more info
on using an IR543.
1.1.
1.1.
1. Press and hold
SETUP until the LED
indicator lights
steadily. Release the
SETUP button.
CC
CC
C
HANGINGHANGING
HANGINGHANGING
HANGING
THETHE
THETHE
THE
X10 H X10 H
X10 H X10 H
X10 H
OUSEOUSE
OUSEOUSE
OUSE
C C
C C
C
ODEODE
ODEODE
ODE
::
::
:
The 5 in 1 Learning Remote defaults to
House Code A, and in most cases you
will not need to change this unless you
are experiencing interference from a
neighboring X10 system.
1.1.
1.1.
1. Press and release
the X10 button.
2.2.
2.2.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3.3.
3.3.
3. Use the number
buttons to enter the
number equivalent to
the chosen House
Code
(1=A, 2=B ..16=P).
4.4.
4.4.
4. Press the ENTER
button to confirm the
House Code. The
LED turns off.
Note: The House Code you choose
must match the House Code on the
Transceiver and Modules you are using it
with.
To Next Page
Loading...
Need help?
General
