X10 UR74A User Manual

1717
1717
17
1616
1616
16
C C
C C
C
ONTROLLINGONTROLLING
ONTROLLINGONTROLLING
ONTROLLING
X10 MX10 M
X10 MX10 M
X10 M
ODULESODULES
ODULESODULES
ODULES
If you have purchased and installed a
Transceiver Module, you can control it
and other X10 modules as follows:
2.2.
2.2.
2. Use the number
buttons to enter the
Unit Code number of
the chosen module.
(You do not need to
enter ‘0’ first for a
single digit number.)
3.3.
3.3.
3. Press the appro-
priate button for the
function you require
(see below).
X10 FUNCTIONS:
On: CHANNEL +
Off: CHANNEL –
Bright: VOLUME +
Dim: VOLUME –
All Lamps On: POWER
All Modules Off: MUTE
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
1.1.
1.1.
1. Press and release the
X10 button.
7.7.
7.7.
7. Repeat steps 5 and 6 for each button you
want to learn.
8.8.
8.8.
8. When you’ve
finished learning all
the keys, press
SETUP.
Notes:
Make sure you have fresh batteries in
both remotes before learning.
Take care not to move either remote
while pressing the buttons.
Experiment with the distance between the
remotes if you have a problem learning.
Some remotes do not have their LED in
the center so you might need to
experiment with the side-to-side position
of the remotes relative to each other.
Do not sit directly under an incandescent
lamp while teaching the Remote.
In most cases you hold the button on the
remote you are learning from until the
LED goes out on the Learning Remote. In
some cases however, you might find that
the LED on the Learning Remote doesn’t
go out until you release the key on the
remote you are learning from.
You cannot store any functions under the
following keys:
Learn, Setup, TV, VCR, Cable, SAT, X10.
You can store up to 50 buttons each for
three different remotes.
RESTREST
RESTREST
REST
ORING THE DEFORING THE DEF
ORING THE DEFORING THE DEF
ORING THE DEF
AA
AA
A
ULUL
ULUL
UL
TSTS
TSTS
TS
If you have problems learning keys, try a
Mode Reset or Master Reset, and then try
learning them again.
Mode resetMode reset
Mode resetMode reset
Mode reset
Press and hold Setup until LED lights,
then press Mode, Learn, Learn, Setup.
This restores the default code for that
particular Mode (TV, VCR, CBL, AUX).
Master resetMaster reset
Master resetMaster reset
Master reset
Press and hold Setup until LED lights,
then press Learn, Learn, Setup. This
restores the default for ALL keys.

X10 UR74A Specifications

General

Brand	X10
Model	UR74A
Category	Universal Remote
Language	English