1313
1313
13
1212
1212
12
SS
SS
S
EARCHINGEARCHING
EARCHINGEARCHING
EARCHING
F F
F F
F
OROR
OROR
OR
C C
C C
C
ODESODES
ODESODES
ODES
1.1.
1.1.
1. Turn on the device
you want to control.
2.2.
2.2.
2. Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
3.3.
3.3.
3. Press the mode
button that matches
the equipment you
want to control. The
LED blinks once.
4.4.
4.4.
4. Press CHANNEL +
repeatedly (note 5,
page 12) until the
device to be
controlled changes
channel.
If you accidentally go
past the code, press
CHANNEL -
repeatedly until the
channel changes
again.
5.5.
5.5.
5. Press and release the
ENTER button to
complete the setup.
The above assumes that you want to
store VCR codes under the VCR key,
Cable codes under CBL, etc. If you want
to store a VCR code under SAT, etc., first
follow the procedure on page 11 and try
ANY SAT code from the code tables, e.g.
press SAT in step 3, page 11, and then
enter ANY VCR code. Then follow the
steps above.
Notes:
1. The TV mode key can only be used to
store TV codes but you can store a
code for ANY device under either the
VCR, CBL, or SAT mode key. E.G.,
you can store a Cable code under
the VCR key, or a Satellite code
under the Cable key, etc.
2. If your TV/VCR/Cable Box does not
respond, try the other codes for your
brand. If it still doesn’t respond, try
the Code Search method on page
13.
3. If the LED blinked rapidly when you
entered the code, you may have
entered an invalid code. Recheck the
code in the code list (separate sheet)
and try again.
4. If some buttons do not operate your
equipment, try one of the other
codes for your brand.
5. When searching for a code (page 13)
you might have to press CHANNEL+
many times (50+). If the device does
not have a Channel Up function, use
the PLAY button (VCR only) or the
POWER button.
To Next Page
Loading...
Need help?
General
