99
99
9
88
88
8
1.1.
1.1.
1. Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2.2.
2.2.
2. Plug a lamp into the
Lamp Module.
3.3.
3.3.
3. Plug the Lamp
Module into a
convenient AC
outlet.
5-5-
5-5-
5-
ININ
ININ
IN
-1 L-1 L
-1 L-1 L
-1 L
EARNINGEARNING
EARNINGEARNING
EARNING
R R
R R
R
EMOTEEMOTE
EMOTEEMOTE
EMOTE
The 5-in-1 Learning Remote lets you
control practically everything electrical in
your home. It has IR technology that lets
you control your TV, VCR, Cable and CD
or DVD player, and X10 RF technology
that lets you control lamps and
appliances anywhere in your home.
To find out more about configuring the 5
in 1 Learning Remote to work with your
audio/video equipment, see the section
titled “Setting Up your Remote.”
1.1.
1.1.
1. Push the tab and lift
off the battery cover.
2.2.
2.2.
2. Fit four AAA
batteries, taking care
to match the + and -
marks in the battery
compartment.
I I
I I
I
NSTNST
NSTNST
NST
ALLINGALLING
ALLINGALLING
ALLING
THETHE
THETHE
THE
CC
CC
C
OMPONENTSOMPONENTS
OMPONENTSOMPONENTS
OMPONENTS
TT
TT
T
RANSCEIVERRANSCEIVER
RANSCEIVERRANSCEIVER
RANSCEIVER
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from the Learning Remote to operate a
lamp or appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X10 modules (also sold
separately). Note that unlike the Lamp
Module you cannot dim and brighten a
lamp connected to the Transceiver
Module.
You should locate the Transceiver Module
centrally in the home for maximum range
when controlled by the Learning Remote.
2.2.
2.2.
2. Plug a lamp or
appliance into the
Transceiver Module.
3.3.
3.3.
3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
LL
LL
L
AMPAMP
AMPAMP
AMP
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Lamp Module (sold separately) may
be used to control any incandescent lamp
rated up to 300W. It is not suitable for
other types of lamp such as fluorescent or
energy saving lamps, or lamps which
include a dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the
Lamp Module. It may damage the
module and the appliance and could
cause a fire hazard.
1.1.
1.1.
1. Set the House Code
to ‘A.’