6. USING THE KEY PAD
After inserting the chip card, press the numeric keys of virtual keypad (Figure 5, as
reference) shown on the display to enter the password. Press Cancel (X) key to
terminate any current function and press the Enter (O) key to confirm a value or an
option.
Figure 5
7.
USING THE CONTACTLESS CARD READER
Tap the contactless card on top of the contactless logo which is shown on the paper
cover. The 4 green LED indicates the contactless card reading status.(Figure 6).
Figure 6
8. CHANGE THE BATTERY
STEP 1: Remove the 2 screws and open the battery cover as Figure 7.
STEP 2: Lift the battery and pull up the battery connector from device as Figure 8
STEP 3: Insert the connector of new battery into the device as Figure 8
Note: Please ensure the orientation of connector of battery cable matches the connector on
the device.
STEP 4: Place the new battery into the compartment
To Next Page
Loading...
Need help?
General
