XAG R150 - Wiring Guideline for Jet Sprayer Control Module

www.xa.com/en 5
Wiring guideline for jet sprayer control module
After the jet sprayers are 󽗉xed, plug the sprayer connection cable into the sprayer connector on the
water pump control box. See the 󽗉gure below for wiring instructions.
Atomization motor
Atomization motor
Pneumatic motor
Pneumatic motor
Pan tilt CAN
CAN of pan tilt
Pan tilt power
Power of pan tilt
Liquid container
power and CAN
Reserved power
and CAN
Wiring of Jet Sprayer Control Module
1. Do not assemble or disassemble any modules while the device is powered on.
2. Turn on the power supply only after all modules have been installed.
Note
Vehicle Front
Vehicle Front
L
AF GM-DC
LS-CAN2
CF
AFGM-DC
CF
CAN1
GM-CAN2CF
GM-CAN2