Installation and Configuration
Initial Inspection
Release 3.1 21
Figure 2.2 RS-232 Interface Subplate
(Located on Power Supply Rear Panel)
CAUTION
Use proper static control techniques to avoid damage to static-sensitive components
on the printed circuit board
S1 Switch
1-1, 2, 3 Baud Rate Selection
1-4 Flow ON/OFF Selection
1-5 XON Switch
Hardware/Software Flow Control Selection
Error LED (ERR)
Indicates that a programming error has occurred.
Clear with error query command.
J7 User Signal
Connector
RS-232 Connector
Note: On some models, the subplate is rotated 180 degrees.
Address LED (ADR)
Indicates that the unit is being
addressed by the master controller.
Switch Position Reference
markings (0) (1)
To Next Page
Loading...
