Installation and Configuration
Power Supply Settings
Release 3.1 31
Power Supply Settings
For serial communication, the computer and the RS-232 interface must share the
same communication settings. Make sure that the settings of the computer and of
the power supply agree with those shown in Table 2.11.
Table 2.11 Power Supply Settings
Parameter Setting
Transmission
Asynchronous
Mode Full Duplex
Speeds 75, 150, 300, 600, 1200, 2400, 4800, 9600
Parity None
Connector DB9-pin Male
Start Bit 1
Stop Bit 1
Data Bits 8
Protocols XON/XOFF
CTS/RTS (DSR/DTR)
NONE
To Next Page
Loading...
