To Next PageTo Next Page
Need help?Do you have a question about the Xantrex XDC 300-40 and is the answer not in the manual?
General| Model | XDC 300-40 |
|---|---|
| Output Voltage | 13.6 Vdc |
| Output Current | 30 Amps |
| Efficiency | 83% |
| Cooling | Fan Cooled |
| Input Voltage | 100-120 Vac |
Details the warranty coverage, duration, and terms for Xantrex products.
Explains Xantrex's commitment to repair or replace defective products under warranty.
Provides instructions on contacting Xantrex or a merchant for warranty service.
Introduces the XDC Series DC power supplies and their key features.
Lists key features like digital processing, auto sequencing, and soft switching.
Describes the components and layout of the power supply's front panel.
Details the connectors and ports located on the rear panel of the unit.
Provides recommendations for inspecting, installing, and testing the power supply.
Outlines the essential steps for setting up the power supply.
Guides on proper rack mounting and ventilation for the power supply.
Explains the requirements and procedures for connecting AC input power.
Introduces powering the supply on/off and front panel controls.
Details the steps and expected behavior when turning on the power supply.
Explains Constant Voltage (CV), Constant Current (CC), and Constant Power (CP) modes.
Describes the function keys, menu navigation, and control knobs.
Introduces remote operation via analog, multichannel, RS-232, and GPIB interfaces.
Illustrates port locations for remote interface connections.
Explains analog interface connections and programming.
Details RS-232 connection, configuration, and SCPI commands.
Introduces current sharing functionality for 6000 Watt units via CANbus.
Explains how power supplies in parallel equalize current draw.
Guides on configuring current share modes (Master, Slave, No Sharing).
Describes calibration procedures for 6000 W units, software-dependent.
Explains how to access calibration mode via front panel or SCPI.
Details calibration steps for output voltage and current.
Outlines calibration steps for analog programming interfaces.
Summarizes SCPI commands supported by the power supply.
Explains SCPI command structure, parameters, and syntax rules.
Provides a comprehensive list of supported SCPI commands.
Explains how errors are queued and cleared in the instrument.
Lists and describes IEEE 488.2 syntax errors.
Lists and describes errors detected by the execution control block.
Lists errors related to abnormal hardware or firmware conditions.
Introduces GPIB interface for programming and communication.
Details multiline control and interface functions for GPIB.
Lists driver requirements and electrical specs for GPIB interface.
General notes on specifications covering operating range and changes.
Provides a summary of electrical specs for 6000W and 12000W units.
Details operating altitude, temperature, humidity, and approvals.
Provides physical dimensions and weight of the power supply units.
