3
1.
Insert Cross Bar①② into Post⑤, adjust their position and make ①② in
parallel.
2.
Insert Side Cross Bar③④ into Post⑤ and mount Connector⑨ on both ends.
3.
Insert Side Post⑥ into connector⑨.
4. Make the drum rack stand firm and fasten all connectors on bars.
5.
Install Cymbal Connector⑩ as the picture shows.
6.
Insert Crash Arm⑦ to Connector⑩ and Ride Arm⑧ to another connector according
to the picture.
7.
Insert Tom Rod⑪ according to the picture, and adjust its connector to suitable
position.
INSTALLATION
②
②
③
④
④
④
①
①
⑤
⑤
To Next Page
