Disassembly and Reassembly
1. To remove the ADF Engine part, first remove the eight
screws securing the ADF Engine part to the Cover
Platen and then release the ADF Engine part in the
direction of arrow.
At that time the TX Stacker automatically release it
self at right side, as shown below.
ADF Engine part
TX Stacker
2. Remove the two screws securing the ADF Harness to
the Cover Connector and then take care to thread the
ADF Harness through the Cover Platen.
ADF Engine part
Connector Cover
ADF Harness
To Next Page
Loading...
