Disassembly and Reassembly
5.20 Bypass Feed Roller
1. Remove the following:
- HVPS 5.14
2. Remove the Feed Pulley and Belt, as shown below.
3. Remove the Feed Gear and then remove the E-ring
from the Feed Shaft, as shown below.
Notice: Be aware of the E-ring and Spring to ensure they
are not lost.
4. To remove the Feed Roller, first pull the Feed Roller
from the Bush and then take out the Feed Roller and
Feed Shaft, as shown below.
Notice : Do not grab the rubber part of the Feed Roller, it
may cause a malfunction due to a foreigen
object.
Belt
Feed Pully
Feed Gear
2
1
Bush
Feed Roller
Feed Shaft
To Next Page
Loading...
