The RTVPREPOST command retrieves the ASCII text and data from the User Space and puts it in the
source member specified. An editor can them be used to make additional changes as needed.
NOTE: The translation from EBCDIC to ASCII/hex in both directions requires that the end of a line be readily
identifiable. Put a “\x0a” at the end of each line when creating a Prepend or Postpend file.
To recall the pre and post pend files enter the RTVPREPOST and press F4 at the command line. Enter the
two member names to retrieve. Make the changes that you want then repost using the CRTPREPOST
command.
To Change the Default Paper Size
With “Paper Size Drawer 1” set to “LETTER” the HPT will send both a specific tray and a specific paper size
commands to the printer. When creating a print queue, the default page size is set to “LETTER” for all the trays.
If A4 will be the default, then change letter to A4 for Source Drawer 1 and 2 when using the CRTXDEVPRT
command.
To Next Page
Loading...
