between is ignored. The compiler will ignore anything between the (/*) and the (*/).
Once the edits are completed and saved, the WSCST needs to be created using either the IBM-supplied
CRTWSCST command or the Xerox-supplied CRTXWSC from the XTOOLS library. Once the WSCST is
successfully created, you must end the writer of the printer you want to use, and then restart it, to pick up the
changes you made to the source member. NOTE: If you are using a device description, you must vary it off, and
then back on, before you restart the writer.
To Previous Page
Loading...
Need help?
General