To Next Page
M
melissa19Sep 12, 2025
What to do if Tray 5 (Bypass) printing failed on Xerox Printer?
- SStephanie JohnsonSep 12, 2025
If printing from Tray 5 (Bypass) fails, follow the displayed instructions to load the correct paper size and try printing again.
What to do if Tray 5 (Bypass) printing failed on Xerox Printer?
If printing from Tray 5 (Bypass) fails, follow the displayed instructions to load the correct paper size and try printing again.
What to do if Xerox D125 Printer documents jam often?
To prevent frequent document jams, ensure the document feeder is properly loaded with acceptable media. Remove any sticky labels, paper clips, or tape from the documents. Properly set the document guides and check for any paper pieces inside the document feeder cover. If you're using mixed-size originals, set the Mixed Size Originals option to ON. When loading A5-size documents, load them vertically.
How to turn on Xerox Printer if power is not switched on?
If the power is not on, first, ensure the power switch is turned on. If it still doesn't power on, turn the power switch off, then firmly plug in the power cord before turning the power switch back on. Also, confirm that the power supply is within the range of 200-240 V and 15 A, and that the power capacity is compatible with the printer's maximum power consumption of 2.8-3.1 KVA.
Why is my Xerox D125 Printer unable to print or copy?
If you're unable to print or copy, first follow any instructions displayed on the printer's screen. Next, press the Machine Status button and select Online from the Printer Mode. If the issue persists, turn the power switch off, firmly plug in the power cord, and then turn the power switch back on.
What to do if I cannot open or close trays on my Xerox Printer?
If you cannot open or close the trays, turn the power off without trying to open or close the tray. Wait a few seconds, then turn the power back on. Ensure the machine is online and ready to receive data before attempting to open or close the tray.
What to do if a corner of the document is folded in my Xerox Copier?
If a corner of the document is folded when using your Xerox Copier, flatten out the curl and load the document again.
What to do if my Xerox Copier shows an error message after loading paper in Tray 5 (Bypass)?
If you receive an error message after loading paper in Tray 5 (Bypass) and pressing Start, ensure that the paper guides are set to the correct positions.
What to do if my Xerox Printer has malfunction and rebooted? (xxx-yyy)
If your Xerox printer has rebooted due to an auto-recoverable internal error, select the Close button on the display. The printer should now be operating normally. If the error continues to occur, contact the Customer Support Center.
Why is my Xerox Copier display dark?
If your Xerox Copier display is dark, first press the Power Saver button on the Control Panel to exit Power Saver mode. If the display is still dark, adjust the display brightness using the Brightness dial.
Why do documents jam often in my Xerox Copier?
If documents jam often in your Xerox Copier, make sure the document feeder is loaded properly with acceptable media. Remove any sticky labels, paper clips, or tape from the documents. Properly set the document guides. Open the document feeder cover and check for pieces of paper. Set Mixed Size Originals to ON. Load the A5-size document vertically.
General| Print Speed | Up to 125 ppm |
|---|---|
| Print Resolution | 2400 x 2400 dpi |
| Standard Paper Capacity | 4, 050 sheets |
| Maximum Paper Capacity | 8, 050 sheets |
| Connectivity | Ethernet, USB |
| Duplex Printing | Standard |
