Xerox Mobile Scanner
User’s Guide
67
Note: if you have configured a wireless network for the Eye-Fi card, you will need to either temporarily disable your
wireless network if possible, or remove the wireless network from the Eye-Fi card and then add it back again when
you are done. If the Eye-Fi card is within range of a configured wireless network the scanned images will be
transferred using the wireless network. Please refer to Adding or Removing Private Wireless Networks on page 40.
Test Scan for the Direct Mode Network
1. Disable your wireless network or remove the network from the Eye-Fi card.
2. Disconnect the scanner from the computer and power cycle the scanner.
3. When the scanner power is back on, insert a photo in the scanner.
4. The scanner scans saves the image to the Eye-Fi card, and the card starts transmitting the image.
5. Open the Eye-Fi application.
6. Tap Connect to connect your mobile device to the Eye-Fi Direct Mode network.
7. When the scanned image appears in the document list you know that the Direct Mode connection is working
as intended.
Note: You can set the application to automatically connect to the Eye-Fi network. When the option is selected, each
time that you scan and open the Eye-Fi application, the device is automatically switched to the Eye-Fi network
without being prompted. From the menu options, press Settings, then Application Preferences, and
Automatically Connect.
To Next Page
Loading...
