EasyManua.ls Logo

Xerox Phaser 3400 - Control Panel

Xerox Phaser 3400
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Phaser 3400 Personal Laser Printer
Control Panel
1. Error light
■ Blinking = Insufficient memory
■ Blinking alternating with the Paper
light blinking = Output tray is full.
■ 2 fast blinks, then off, then 2 fast
blinks, then off, etc. = Toner is
getting low. Replace the laser print
cartridge soon.
■ On = Cover open, cartridge not
installed or not seated properly
■ On with Paper light = Paper jam
2. Manual-feed
light
■ On with Data light = Ready for a
manual-feed job. Load paper in the
multi-purpose tray and press the
Print button to start the job.
3. Paper light
■ On = Out of paper
■ On with Error light = Paper jam
■ Blinking alternating with the Error
light blinking = Output tray is full.
4. Data light
■ On = Ready to receive data
■ On with Manual-feed light = Ready
for a manual-feed job
■ Slow blink = Receiving data
■ Fast blink = Printing
5. Cancel button
■ To cancel a print job, hold down the
Cancel button until all lights blink,
then release the button.
6. Print button
■ When the Manual-feed light is on
and paper is loaded in the
multi-purpose tray, press the Print
button to feed the paper into the
printer.
■ To print a Configuration Sheet, hold
the Print button until all lights blink,
then release the button.
If all lights are blinking, this indicates a system error. Turn the power off and
then back on to clear. If the problem persists, contact Xerox Customer Support.
1
2
3
4
5
6