56. Rotate the remaining end cap and partially install on the
frame so that the rear tab locks into place.
57. Install the spring from the end cap to the hopper.
58. Pull the seal tab through the end cap seal slot. 59. Align and snap the end cap into place.
XEROX PHASER 3600 • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
